iOS What's New

Improved Error Messages and Easily Send Logs

When getting errors, an improved error message will be displayed in the red message bar and a button will be available on that error bar to send the log.

Checkpoint Speed Improvement

1) When configured, checkpoints can now mask the Route information of the scanned parcel to increase scanning speed. When accordingly set in Dispatch Science, the information about the route which is usually shown at the bottom of the screen above the Complete will no longer we displayed:

2) A 1.5 second delay is added between scans using the camera to ensure the same barcode is not scanned twice however, if a new barcode is scanned within the 1.5 second, it will be scanned. The 1.5 second is only used when scanning the same barcode more than once.

List of Unsuccessful Scans in Continuous Scan Mode

When a checkpoint is set as continuous scan, the list of unsuccessful scans now appears at the bottom of the list when opening Items. This icon will now reset each time you open Items to ensure that once it has been reviewed, you will only need to review it again once the warning icon reappears.

1) Tap on See Items while scanning at Checkpoint in a checkpoint set as continuous scan when you see the fail icon that indicates there are unsuccessful scans:

2) Verify the list of failed barcodes then tap Cancel or Ok:

3) On returning to the scan, notice the fail icon is no longer visible:

Bug Fixes

- If one stop on a grouped stop was closed, the stop was still showing in the grouped list.

- In Dark mode, the disabled checkboxes should be blank and enabled checkboxes should be white.

- On pickup and delivery of grouped orders with long descriptions, when driver tapped See items and scrolled down the list of items, the list would get jumbled during the scroll.

- When using the checkpoint on My Run, part of the status bar was cutoff at the bottom.